160W Monocrystalline Folding Solar Panel

160W Monocrystalline Folding Solar Panel

Specifications

Solar panel typeMonocrystalline
Wattage160W
Voltage13.4-14.03V
Open circuit voltage22.4V
Peak current output8.75A
Regulator typePWM (Pulse-Width Modulator)
Dimensions770*670*65mm
Extension lead5m
Solar regulator IP RatingIP68
Warranty12 month

Function and Features

  • Highly efficient monocrystalline modules in the solar panel guarantee efficient charging.
  • When the 160W folding solar panel is folded up, it’s space-saving and portable; when the folding solar kit is open, it has double the sunlight charging area,providing a good consistent charge. 
  • The regulator is designed to protect the battery from overcharging under voltage,as well as short circuiting.
  • Specially designed support legs enable the 160W folding solar panel to stand on rough surfaces, and on a desired angle for direct sun exposure.

Included in the kit

USING YOUR 160W FOLDING SOLAR PANEL: 

The Adventure Kings 160W folding solar panel will perform at its peak when the solar panel face/monocrystalline cells are angled directly towards the sun. Set the legs to your desired position:(below) 


TWO STEPS FOR USING THIS ADJUSTABLE SUPPORT LEG 

1.When the locking handle is at 90 degrees a right angle. The support legs are loose and the angle of the solar panel can be adjusted.

2.When the locking handle is in the down (45 degree)position, the support legs are locked and cannot move or shake at all. 


CONNECTING YOUR SOLAR PANEL 

1.Now that the panel is set up facing directly towards the sun. Proceed to connect the positive and negative clamps to your battery.

2.DO NOT connect the solar panel straight to the battery or it will damage the Solar controller.

3.Always connect the battery clamps to the battery first, then plug the solar panel Anderson plug into the battery cables Anderson plug. Your regulator will then light up to show that it is working. 


DISCONNECTING AND STORING YOUR SOLAR PANEL 

1.Disconnect the Anderson plug off the battery clips first and then proceed to take the battery clips off the battery.

2.Roll the extension lead up neatly into the storage clips behind the Solar panel. NOTE: MAKE SURE NOT TO TWIST OR KINK THE WIRING IN AN UNNATURAL WAY.

3.NEVER STORE YOUR SOLAR PANEL WITH THE BATTERY LEADS CONNECTED TO THE PANEL.

4.PLACE THE BATTERY LEADS SEPERATELY IN THE FRONT POCKET OF THE CARRY BAG.